Ceiling Mounted Hanging Ornament Rotator Spinner

Tell A Friend!

Light Duty (3 oz capacity) Battery Operated Suspended Ceiling Ornament Rotator

Stock# 8165554 Click here to see the back and the drop ceiling clip. $8 + S/H

Show off those large, lightweight items/ signs or ornaments that are decorated on both sides. Adding a length of decorative ribbon to this 4" square ornament rotator will lower the display height of your item to a comfortable level for viewing. Holds lightweight  ornaments, decorations or collectibles weighing up to 3.5 - 4 oz. Watch in fascination as your collectible goes around and around. Includes a clip for use on the rails of suspended ceilings. Manufacturer states the dark green ornament spinner rotates slowly at approximately 1-2 RPM for up to 1,000 hours on one AAA battery which is included. Has on/off switch. Weigh your collectible or decoration to make sure it is 3 oz or less.

Heavy Duty (8 lb capacity) Battery Operated Suspended Ceiling Ornament Spinner; Open Battery Compartment

Stock# 83405  $24 + S/H Includes 1 suspended and 1 regular ceiling clips. One 3" S-hook is Optional but included with most orders.

Attach a ceiling mounted ornament displayer for maximum impact! Here's another option for hanging ornaments or other decorations from a suspended ceiling or ceiling joist. Black rotator runs on 1 "D" cell battery (not included). Top section contains the battery, lower section contains motor housing, spinner is attached to the lower section. No on/off switch.  Holds up to 8 pounds. Mount the suspended ceiling cross bar clip, attach the spinner, then add your decoration. This rotator is intended for commercial use and installation. Commercial suspended ceilings are heavier than the typical residential installation. Also, you can not see this in the photo however, ONE SIDE OF THE BATTERY COMPARTMENT IS OPEN. Manufacturer says a fresh battery could run 24 hrs a day for 1 week before replacement. Entire assembly with all clips and the optional 3" suspended ceiling S-hook is 11-1/2" long and 1-1/2" in diameter. Rotates at approx. 4 rpm's. Please go here to download the assembly instructions. Have a knowledgeable expert check your ceiling to make sure that it will support the weight of the rotator and your decoration and do the install.